Published by nada Belmokhtar in Academic
I'm a student on water engineering I'm designing a plant and the concentrate flux is less than the minimum how I can increase it without changing the permeat flux or recovery. thank you.
Category: Academic
you can increase flow trough the vessels by changing from christmastree design to a feed and bleed mode.
Published by Markus Kyburz, Owner, at Kyburz Consulting
You can recirculate some concentrate back to the inlet.
if there are multiple vessels change the number of stages and vessels per stage.
Published by David Averbeck
You can use a successive RO process where in the first stage you can set a higher level of flux of reject, using the reject for the second phase RO, and use the reject form second for third stage. After the direct membrane filtration of wastewater, a typical phases of recovery can be 65%, 10% and 5%. Based on the feed water quality you can increase or decrease the flux on rejects. I hope that helps.
Published by Bhupen Patel, Employee at ClearCove Systems
thank you
Published by nada Belmokhtar