Published by Linus Kapulwa
Hi everyone,
We have a problem of lamellar tubes that keep on popping out of array, even after cleaning the settler. what cause this ?
Thank you
Thank you everyone for advise, my email shall follow.
Published by Linus Kapulwa
Did you check the load?
You need to test settling rates with your supplier.
Sometimes, Pamela is not a good choice for the type of suspended solids.
Published by Heloisa Yamaguchi, Especialista em sistemas de tratamento de águas, efluentes e reuso
Did you check the load?
You need to test settling rates with your supplier.
Sometimes, Pamela is not a good choice for the type of suspended solids.
Published by Heloisa Yamaguchi, Especialista em sistemas de tratamento de águas, efluentes e reuso
Yes, it happens when the lamellae are too thin! Take this into consideration! You need at least 2 mm of thickness, but most of the suppliers don't provide that. I supply 3 mm lamellas, If you need support, I can help you: nicolas@1h2o3.com
Published by Nicolas Meudal, Freelance Wastewater & Water Consultant
Hi Linus, could be an inherent process condition, operation or maintenance issue, or simply poor supply and service
you are welcome to contact me at gary@dikubu.co.za for further support and insight
regards
Published by Gary Brown, Water Practitioner at Dikubu Water
Hey Linus Kapulwa different reasons could cause the problem. For example: Flow turbulences, Support structure, Material, Clogging. Can you give us some more information on the design? Our email address is info@aqua-equip.com
Published by Karl-Uwe Schmitz, President at Aqua Equip Technologies LLC (AET LLC)