Surge Analysis for STORM

Published by

Can anybody tell me which software should be used for surge analysis in STORM pumping station?

Tags

6 Answers

Actually, the very best surge ...

Actually, the very best surge modeling software is InfoSurge by Innovyze (http://www.innovyze.com/products/surge/). It is the fastest computational engine available, can solve systems with unlimited numbers of pipes, and has been proven over and over again by the largest utilities around the globe. 

Published by

1 Comment

Water Hammer by bentley

Water Hammer by bentley

Published by

1 Comment

We use Multistage Centrifugal ...

We use Multistage Centrifugal Pumps for pumping out storm water Channel . However no soft were was used

Published by

1 Comment

We use Multistage Centrifugal ...

We use Multistage Centrifugal Pumps for pumping out storm water Channel . However no soft were was used

Published by

If you are referring to surge ...

If you are referring to surge in terms of hydraulic transients, HAMMER by Bentley is a good product.  

Published by

...

http://www.flo-dyne.net/Surge%20Analysis.html  offers an integrated hardware and software soultion(s). However, in situations where existing infrastructure is in place, then specific software would need be developed and integrated to a given configuration, Essentially a Physics solution coupled with engineering and automated controls all dependent upon the anticipated size of the surge, and communications. From Tsunami's to mere higher or lesser flows, this can be automated. Each case is therefore different. I suggest going to GitHub github .com for the proper software elements, languages, et cetera. Obviously, information from weather satellites also are in the mix. Development of an automated system is the only solution that is feasible generally. Physicists, Computer Scientists,and of course, Engineers need to be assembled. The question is broad and important for humanity.

 

Published by

1 Comment